11 OPTION menu
11.1 RAPID mode
In flash modes A and TTL, the recycling times
depend on how much light is needed for the
exposure. If the recycling time is too long, the
RAPID function can be switched on in the A
and TTL flash modes. The RAPID function is
recommended especially in cases where fast
recycling times are more important and maxi-
mum flash
output is less important, such as in relatively
small spaces. However, the guide number is
reduced by 1 level, e.g. from a guide number
of 36 (at ISO 100 zoom 35) to guide number
25 (at ISO 100 zoom 35).
Setting procedure
• Press the
for the selection menu to appear.
OPTION
k
• Press the
OPTION
touch display.
• Press the
touch display and select
RAPID
• Press the
SUB-REFL.
touch display.
p
q
• Press the
the touch display and switch the RAPID
RAPID
function on or off.
The setting is adopted immediately.
OFF
After activation of the RAPID function, „
appears in the display.
ON
174
button as often as it takes
OPTION
sensor button on the
sensor buttons on the
RAPID
.
RAPID
sensor button on the
ON
OFF
or
sensor button on
"
11.2 Secondary reflector (SUB-REFL.)
The secondary reflector is used for frontal
brightening when using a bounce flash if the
main reflector is tilted sideways or upwards.
If the light from the secondary reflector is too
large, it can be reduced by half.
Setting procedure
• Press the
for the selection menu to appear.
OPTION
• Press the
touch display.
OPTION
RAPID
• Press the
SUB-REFL.
touch display and select
ZOOM SIZE
• Press the
p
q
touch display.
SUB-REFL.
• Press the
ton on the touch display and switch the
OFF
secondary reflector on or off. The setting is
1/1
adopted immediately.
1/2
Upon switching on the secondary reflector,
appears on the display
„ 1/1" or „ 1/2" is displayed in the INFO
menu.
1/1 means full light output, 1/2 means half
light output.
button as often as it takes
OPTION
sensor button on the
sensor buttons on the
SUB-REFL.
.
SUB-REFL.
sensor button on the
1/1
1/2
OFF
,
or
sensor but-