Metz mecablitz 64 AF-1 digital Mode D'emploi page 1141

The maximum possible frequency of flashes
+
(f) depends on the set partial light output
(P).
Setting the mode of operation
• Switch on the flash unit with the
button.
The start screen appears. Thereafter, the
flash unit always switches on with the
PTTL
mode of operation that was used last .
• Press the sensor button of the displayed
0.8- 9.0 m
mode of operation on the touch display as
M-
5,6
many times as it takes for the display for
35 m
Zoom F
m
selecting the mode of operation to appear.
EV
MODE
• Press the
M
touch display and select
STROBO
• Press the
SPOTBEAM
touch display.
p
q
STROBO
• Set a suitable mode of operation on the
M-
3.1m
camera, e.g.
35 m
Zoom
m
• Tap the shutter release to transfer data bet-
5 5
N f(Hz)
ween the flash unit and the camera.
P
1/8
sensor buttons on the
STROBO .
STROBO sensor button on the
M
.
Setting number of flashes (N)
STROBO
• Press the sensor button for the number of
M-
2,2m
35
m
Zoom
flashes
m
5 10
N f(Hz)
P
1/16
N
• Press the
3
touch display and select the desired num-
4
ber of flashes.
5
p
q
+
The maximum possible number of flashes
(N) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired number of flashes
(in the example
The setting will take effect immediately.
N
on the touch display.
sensor buttons on the
4
.
179
k