Metz mecablitz 64 AF-1 digital Mode D'emploi page 1476

10.2.5 Setting partial light output/exposure
RMT Ch
REMOTE
SLAVE 2 2
• Press the sensor button on the touch
M-
display for the partial light output/exposu-
Zoom 24
re correction (e.g
for the selection appears.
P
1/1
SLAVE
• Press the sensor button on the touch
display for the desired mode of operation
TTL
M
EV / P
P
• Press sensor buttons
touch display and set the desired partial
1/4 - 2/3
light output to 1/1, 1/2, 1/8 or 1/256.
1/8
1/8 - 1/3
The partial light output is adopted.
k
Once the slave flash units have achieved
p
q
flash-readiness, the AF measurement flash
flashes.
188
correction
1/1 / EV ) . The window
P EV
or .
on the
10.3 Testing remote flash mode
• Place the slave flash units in the desired
positions for the shot.
Use flash unit mounting foot S60 to set up
the slave flash unit.
• Wait for all of the flash units involved to
become flash ready. Once the slave flash
units are flash ready, the AF auxiliary ligh
will blink.
• Press the manual firing button
master flash unit to fire a test flash.
The slave flash units will respond in succes-
sion, according to slave group, with a test
flash. If a slave unit fails to fire a test flash,
check the settings for remote channel and
slave group. Correct the position of the sla-
ve flash unit so that it is able to receive
light from the master flash unit via the sen-
sor
.
The flash mode is transmitted automatically
by master.
When the flash unit functions as master in
the cordless remote system, the activation of
the modelling light also activates the model-
ling light of slave flash units.
on the