Metz mecablitz 64 AF-1 digital Mode D'emploi page 1456

Masquer les pouces Voir aussi pour mecablitz 64 AF-1 digital:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 382
The active automatic unit switch-off is shown
in the INFO display.
The flash ready indicator
tors on the LC display disappear.
200
The
mode.
The most recently used operating setting is
retained after automatic shutdown and is
immediately restored when the camera is
switched on.
The flash unit can be turned on again by
pressing the
the shutter release (wake-up function).
+
In slave-/ servo mode, the automatic cut-off
is not activated.
The flash unit should always be turned off
using the main switch
to be used for an extended period!
If necessary, the Auto OFF function can be set
k
to occur after 1 minute of inactivity, or can be
deactivated.
The flash unit switches off completely about
1 hour after its last use. In all operating
modes, the brightness of the screen is redu-
ced by 50 per cent after approx. 10 seconds
to save energy. The screen brightness is
restored again whenever a button or a sym-
bol on the screen is pressed.
168
and the indica-
button flashes red in stand-by
button, or by tapping on
if it is not going
Setting the automatic unit switch-off
• Switch on the flash unit with the
ton. The start screen appears. The flash
unit always switches on afterwards with the
mode of operation that was used last (e.g.
manual flash mode M).
• Press the
for the selection menu to appear.
• Press the
OPTION
touch display.
OPTION
ZOOM MODE
• Press the
touch display and select
STANDBY
MOD. LIGHT
p
q
• Press the
STANDBY
touch display.
OFF
1 min
• Tap the sensor button on the touch display
for the desired time. The setting is adopted
10 min
immediately.
The
button flashes red in stand-by
mode.
but-
button as often as it takes
OPTION
sensor button on the
sensor buttons on the
STANDBY
.
STANDBY
sensor button on the

Publicité

Table des Matières
loading

Table des Matières