Metz mecablitz 64 AF-1 digital Mode D'emploi page 1473

10.1.5 Remote channel settings
There are four independent remote channels
to use so that multiple remote systems in the
same room do not interfere with one another.
Master and Slave flash units belonging to the
same remote system must be set to the same
remote channel.
• Press the
for the selection menu to appear.
• Press the
PARAMETER
touch display.
PARAMETER
• Press the
ZOOM
touch display.
CHANNEL
RATIO
p
q
CHANNEL
• Press the
CHANNEL 1
touch display and select a remote channel,
e.g CHANNEL 2
CHANNEL 2
• Press the sensor button on the touch
CHANNEL 3
display for the desired channel.
p
q
The setting will take effect immediately.
Press
i
button as often as it takes
PARAMETER
sensor button on the
CHANNEL
sensor button on the
sensor buttons on the
.
and check the channel setting.
10.2 Remote slave flash mode
The flash unit supports the wireless remote
system in slave flash mode and is compatible
with the Sony system.
At the same time, one or more slave flash
units can be remotely controlled from one
master flash unit on the camera (e.g. meca-
blitz 5 64AF-1S digital).
A slave flash unit can be assigned to two of
three possible slave groups (RMT, RMT2). The
master flash unit can control all of these sla-
ve groups simultaneously and at the same
time take the settings for each slave group
into account.
So that multiple remote systems in the same
room do not interfere with one another, there
are four independent remote channels avai-
lable (CH 1, 2, 3 or 4).
Master and slave flash units belonging to the
same remote system must be set to the same
remote channel.
The slave flash units must be able to receive
the light from the master flash unit with the
integrated sensors for the remote mode .
Depending on the camera model, the came-
ra's internal flash unit can also function as
master flash unit.
k
185