Charging The Battery - Fronius Acctiva Professional Flash Instructions De Service

Charging the battery

Starting charging
1
2
3
4
5
IMPORTANT! If the battery voltage is < 1.0 V, the battery will not be automatically detect-
ed. Charging must be started manually.
CAUTION! Risk of damage when attempting to charge a faulty battery. Before
charging, ensure that the battery to be charged is fully functional.
CAUTION! When refresh charging is selected: risk of damage of the on-board
electronics by refresh charging.
Before beginning refresh charging, disconnect battery from vehicle power supply.
Select the corresponding operating mode by pressing the info button
Set the capacity of the battery to be loaded using the „up" and „down" buttons
After the battery capacity has been set, the charging current calculated from this is
shown on the display.
Connect (+) charging terminal to positive pole on battery
Connect (-) charging terminal to negative pole on the battery, or to vehicle body (e.g.
engine block) in the case of vehicle electrical systems.
Charger detects that the battery is connected, carries out a self test and starts charg-
ing.
Self test E.g.: charging
55