Interrupting Charging; Finishing Charging/Disconnecting The Battery - Fronius Acctiva Professional Flash UCN US Instructions De Service

Charging 3.
(continued)
Interrupting 1.
charging
2.
3.
Finishing char-
ging/disconnec-
ting the battery
1.
2.
3.
4.
When the battery is fully charged, the charger begins conservation charging.
NOTE! during charging (standard charging, user charging), increased demand
for current can lead to a drop in battery voltage (e.g. switching on additional
consumer loads). To compensate, the charger can briefly increase the current
to the maximum charging current (see Technical Data, user-defined settings in
USER menu).
Press Start/Stop button to interrupt charging
Press the Info button to display the parameters in the following sequence:
- actual charging current
- actual battery voltage
- amount of charge (Ah) fed in so far
- energy (Wh) fed in so far
- length of time charging so far
Press Start/Stop button again to resume charging
Self test
CAUTION! Risk of sparks when disconnecting the charging terminals. Before
disconnecting the charging terminals, stop charging by pressing the Start/Stop
button.
Finish charging
Disconnect (-) charging terminal from battery
Disconnect (+) charging terminal from battery
- all bars are permanently displayed
- The battery is 100 % charged
- Battery is always ready to use
- Battery can remain connected to charger for as long
as required
- Conservation charging counteracts battery self-
discharge
E.g.: charging continues
12