Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
2
3
4
5
Display of charge
progress during
charging
IMPORTANT! the charger automatically switches over to conservation charging after ap-
prox. 3 - 7 hours, depending on the type of battery. To charge the battery completely, the
battery should remain connected to the charger for this length of time.
Connect (+) charging terminal to positive pole on battery
Connect (-) charging terminal to negative pole on the battery, or to vehicle body (e.g.
engine block) in the case of vehicle electrical systems.
Press start/stop button for approx. 5 secs
A query regarding correct polarity of the charging terminals is displayed:
Starting the charging process confirms the correct polarity connection. If there is no
confirmation of correct pole connection within 2.5 secs, the device reverts to menu
mode.
Ensure charging terminals are connected to correct poles
Start charging by pressing the start/stop button
The charger starts charging.
During charging, the number of bars indicates how charging is
progressing.
Final charging stage - once the battery is approx. 80 - 85 %
charged.
-
-
NOTE! Only in Refresh charging mode: When refresh charging has finished, the
machine switches off. Conservation charging does not take place.
When the battery is fully charged, the charger begins conser-
vation charging.
-
-
-
-
-
NOTE! To compensate, the charger can briefly increase the current to the maxi-
mum charging current (see Technical Data, user-defined settings in USER
menu).
Display shows 6 consecutive bars
Battery is now ready for use
all bars are permanently displayed
The battery is 100 % charged.
Battery is always ready to use.
Battery can remain connected to charger for as long as re-
quired.
Conservation charging counteracts battery self-discharge.
57
Publicité
Table des Matières
