Fronius Acctiva Professional Flash Instructions De Service page 54

52
370 mm
42 mm
Insert the fitting bracket into the left
1
and right-hand sides of the ventilation
grille on the charger's front panel, and
do the same on the rear panel
Mark the location of the holes on the
2
mounting surface (see diagram for
measurements)
Drill holes
3
Select the most suitable screws for fas-
4
tening the charger according to the na-
ture of the mounting surface (diameter
5 mm)
Fasten charger to the mounting sur-
5
face using fitting brackets, each with
two screws