Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
External power supply
Starting the exter-
1
nal power supply
IMPORTANT! Start external power supply manually if:
-
-
Starting the exter-
nal power supply
manually
60
Select FSV/SPLY mode by pressing the info button
2
Connect (+) charging terminal to positive pole on battery
3
Connect (-) charging terminal to negative pole on the battery, or to vehicle body (e.g.
4
engine block) in the case of vehicle electrical systems
Charger detects that the battery is connected, carries out a self test and starts ex-
ternal power supply.
Self test
By pressing the info button, the parameters are displayed in the following sequence:
-
actual charging current
-
actual battery voltage
-
amount of charge (Ah) fed in so far
-
energy (Wh) fed in so far
-
length of time charging so far
there is no battery connected to the vehicle
the battery voltage on the connected battery is < 1.0 V
CAUTION! Risk of serious damage as a result of incorrectly connected charging
terminals. The reverse polarity protection facility is inoperative if the external pow-
er supply is started manually.
Connect charging terminals to correct poles and ensure proper electrical connec-
tion to vehicle terminals.
-
the maximum voltage command value set in the
USER menu is shown in the top half of the dis-
play.
-
the current parameters are shown in the bottom
half of the display.
Publicité
Table des Matières
