BORETTI CFBI9015IX Prescriptions De Montage Et Mode D'emploi page 248

Telescopic sliding shelf supports (fig. 6.3)
Fig. 6.3
LH sliding
Short bend
guide
Long bend
Fig. 6.6
Fig. 6.7
The telescopic sliding shelf support makes it safer and easier to insert and
remove the oven shelf.
It stops when it is pulled out to the maximum position.
Important!
When installing the sliding shelf support, make sure that:
* You fit the RH and LH sliding guides on the wire support (fig. 6.4).
* You press the RH and LH sliding guides against the fixing wires
(fig. 6.5). You will hear a click as the safety locks clip over the wire.
* You fit the oven shelf above the sliding shelf support (figs. 6.6, 6.8).
* You slide, on the guides inside the oven cavity, the sliding shelf
support with the oven shelf fitted above:
– the oven shelf shall run out towards the oven door;
– do not use the top shelf position;
– the short bend on the wire support shall face the inside of the oven;
– the oven shelf must be fitted so that the guard rail faces the inside
of the oven.
RH sliding
guide
Fixing wires
Wire support
Guard rail
248
Fig. 6.4
Fig. 6.5
Fig. 6.8
2
2
1