BORETTI CFBI9015IX Prescriptions De Montage Et Mode D'emploi page 247

Inside of oven
The oven should always be cleaned after use when it has cooled down.
The cavity should be cleaned using a mild detergent solution and warm
water. Suitable proprietary chemical cleaners may be used after first
consulting with the manufacturers recommendations and testing a small
sample of the oven cavity. Abrasive cleaning agents or scouring pads/cloths
should not be used on the cavity surface.
Note
The manufacturers of this appliance will accept no responsibility
for damage caused by chemical or abrasive cleaning.
Let the oven cool down and pay special attention no to touch the hot
heating elements inside the oven cavity.
Fire risk! Do not store flammable material in the oven.
Oven fitting out
* Assemble the wire racks to the oven
walls using the 2 screws (fig. 6.1).
* Slide in, on the guides, the shelf and
the tray (fig. 6.2).
The rack must be fitted so that the
safety notch, which stops it sliding
out, faces the inside of the oven;
the guard rail shall be at the back.
* To dismantle, operate in reverse order.
Guard rail
247
Stop notch
Fig. 6.2
Fig. 6.1