BORETTI CFBI9015IX Prescriptions De Montage Et Mode D'emploi page 222

If no pan is detected
If no pan is detected on rear cooking zone the front cooking zone display
shows the selected setting and the rear cooking zone display will alternate
between the and
the selected setting).
If no pan is detected on front cooking zone the front cooking zone display
shows the symbol
between selected setting and
operate at the selected setting).
If after 10 minutes no pan is detected:
* the bridging function will switch off.
* the cooking zone without a detectable pan will continue to show
* the remaining cooking zone will continue cooking at the selected heat
setting.
"Fast heating" function
Turn the control knob anti-clockwise to the A setting and then release the
knob (after the "beep"); the relative
zone display. Within 10 seconds turn the knob to the desired power level
(between 1 and 9); once a setting has been selected,
power level will flash in alternation on the control panel display.
This function allows the cooking zone to operate at the maximum power
(100%) for a time proportional to the selected power level; after this time
the cooking zone will operate at the selected level.
This function is available on all the cooking zones.
While this function is operating it is possible, at any time, to increase
the selected power level but it is not possible to decrease the power;
by turning the knob anti-clockwise to a lower level the function will be
disabled.
The function will be disabled also by turning the knob to the "0" (Off)
position or by selecting the "Booster" function.
Note
If removing the pan from the cooking zone before the programme
has been completed, the "Fast heating" function will be completed
with the remaining time if the pan is put back on the cooking zone
within 10 minutes.
(CAUTION! the front cooking zone will operate at
and the rear cooking zone display will alternate
(CAUTION! the rear cooking zone will
symbol lights up on the cooking
222
.
and the chosen