Burkert 0911 Instructions De Service page 9

CHANGING SET-VALUE 1 / SET-VALUE 2
ENTER PROGRAMMING LEVEL
USER LEVEL PR1
SERVICE LEVEL PR2 (PASSWORD 321)
ADDING/REMOVING PARAMETERS IN THE USER LEVEL PR1
6 - 0911
Hold down the SET button for 2 seconds.
Change the set-value within 10 s with the
buttons.
You can save the new set-value by briefly pressing
the SET button or by waiting 10 seconds.
Hold down the SET1 +
seconds.
Select with Pr2 and then confirm with the SET1
button.
Enter the password 321 and then confirm with the
SET1 button.
Enter the „3" and then 1 x SET1 button
Enter the „2", and then 1 x the SET1 button
Enter the „2", and then 1 x the SET1 button
You are now in the Parameter List.
Hold down the SET1 +
seconds. PR1 contains all the parameters that can
be accessed by the user. The device shows the first
parameter that is available in the user level.
See: Accessing the programming level
Accessing the programming level
The status can be changed with the SET1 +
buttons.
If a parameter is not visible in the PR1 level, this will
be indicated by an LED point.
or
button for at least 3
button for at least 3