Burkert 0911 Instructions De Service page 15

Alarms
Status of the control relay
tbA
after acknowledgement
(any button) in any
alarms ituation
AS Configuration of the alarm
relay at an alarm
Measured value display
Lower analog
LCI
Display value
(-1999...1999)
UCI Upper analog
display value
(-1999...1999)
rES Resolution
ATTENTION!
NOTE
UdM Units
PbC Type of sensor
Temperature sensor U):
Current / voltage input
(AU)
1
Only for devices with an input of 4...20 mA or 0...1 V or 0...10 V
2 Only for current or voltage input
12 - 0911
oFF = Relay deactivated
on = Relay activated
cL = Terminal 5-6 closed
oP = Terminal 5-6 closed
Lower display value at current input
4 mA or at voltage input 0 V
(only for the inputs 0-20 mA, 0-1V,
0-10 V)
Upper display value at current input
20 mA or at voltage input 1 V or 10 V
(only for the inputs 0-20 mA, 0-1V,
0-10 V)
Selecting display resolution
in = integer (-99...+199)
dEC = 1 decimal point (-99.0...199.0)
cE = 2 digits after the decimal point
(-99.00...199.00)
irE = large measuring range
(-999...1999)
If rES is changed at a later time, the following parameters must
be checked::
SET, Hy1, LS1, uS1, ALL, ALu, ALH, LCi, uCi, LAo, uAo, HES
Selecting a decimal point is not possible for thermocouples.
Display of the units directly in the
illuminated display. Regardless of which
controller type is being used:
see General description
Type of inout
J = Thermoelement „J"; Pt = Pt100;
C = Thermoelement „K"; Ptc = PTC;
S = Thermoelement „S"; ntc = NTC
cur = 4...20 mA; 0-1 = 0...1 V;
10 = 0...10 V
1,2
1,2