Soft-Start Function - Burkert 0911 Instructions De Service

MEASUREMENT LIMITS FOR THE SENSOR TYPES
Sensor
NTC
PTC
Pt100
TcK
TcJ
TcS
2.4

SOFT-Start function

dSI = Increase the set-value in steps (in °C or °F; deactivated with 0).
dSt = Cycle time for the step-by-step increase of the set-value
(1...3600 sec).
drb = Increasing the set-value (in °C or °F); the function is deactivated with
drb = 0. This value determines the set-value increase in steps in Kelvin
or °F.
drb Soft-Start range (in °C or °F; deactivated with 0). If the temperature
is outside this range (on both sides of the set-value),
a new SOFT-Start will be initiated.
dSI Dynamic set-value increase (in °C or °F; deactivated with 0). This
value determines the step-by-step increase of the set-value of SET1.
dSt Clock time for the dynamic set-value increase (1...999 sec) or dSl
(SOFT-Start).
Ta = Measured temperature after device commissioning.
t = Time axis.
8 - 0911
Lower limit
-40 °C
-50 °C
-200 °C
0 °C
0 °C
0 °C
Upper limit
110 °C
150 °C
600 °C
1300 °C
600 °C
1400 °C