- Telephone Answering Machine -
Button
8
9
0
*
#
On-hook
14.9.5
Remote activation of the answering machine
The remote access feature enables the answering machine to be switched on
via any telephone which uses the tone dialling method.
M
*, M
If the security code is entered incorrectly three times, the line is
automatically disconnected.
9
Other functions can be executed via the remote access system
within the following 10 seconds. Refer to the table in Chapter
14.9.4.
Replace receiver
14.9.6
Free of charge pre-remote access
The free of charge, pre-remote access function can be used to determine
whether messages have been left on your answering machine without
accruing any telephone charges.
To do this, set the "Delay taking calls" function to "toll-saver". Refer to
Chapter 14.3.3.
When you subsequently call the answering machine while underway, the
answering machine responds as follows:
S If your call is taken after 2 rings, there are messages on the
answering machine.
S If no messages have been recorded, the call is not taken after 2
rings. Replace the receiver immediately because the call will be
taken after 5 rings. No telephone charges are necessary because
no connection has been made.
160
Functions
Switch off answering machine
Switch on answering machine / Select outgoing message
Delete all old messages
Skip outgoing message
Record the memo
End remote access
Dial your own phone number
Wait 15 rings, press during the
outgoing message and enter
security code
Switch on the answering
machine and select the
outgoing message mode
End remote access