Operation - Handset Pairing / Mode Selection Twin Axle Mode (Onlyone Driven Axle); Awd Mode (Twin Axle, Both Driven) - Carbest Cara-Move Manuel D'utilisation

Operation - Handset Pairing / Mode Selection
Twin Axle Mode (onlyone driven axle)
Ensure batteries are installed into the handset as explained in previous section (Operation - Handset
functions). Turn on isolation switch to provide power to the electronic control unit (2), a solid red LED
will illuminate. Double press the power button (Fig.13.A) to turn on handset.
On your handset (1), press and hold [ENG] (Fig.13.I) and [DENG] (Fig.13.J) for 1 second to enter
pairing mode. The indication LED (Fig.13.B) on your handset should continuously flash green. Press
the small sync button as shown in Fig.15 on your electronic control unit (2). The LED on this box
should quickly flash red, before producing a small clicking noise. The indication LED (Fig.13.B) on
your handset should go solid green, and the LED on the electronics control unit (2) change to a slow
red flash to indicate the two are paired.
The handset will be in Single Axle mode by default. To select Twin axle mode, press and hold [RL]
(Fig.13.G) and [FN] (Fig.13.K) for 5 seconds. The handset will bleep once to indicate the mode has
been set to Twin axle. Once set, the handset and control box will remember their paring, and will be
fully operational simply by powering on.

AWD Mode (twin axle, both driven)

To configure your system for AWD mode, the handset (1) must be paired with only the front axle
electronic control unit (2). To do this, first ensure that as per section 'Installation - Electrical/Electronic
Components (AWD Configuration)' the data cable (4) is correctly connected to the two control units.
Ensure batteries are also installed into the handset as explained in previous section (Operation -
Handset functions).
Turn on isolation switch to provide power to both control units, a solid red LED will illuminate on each
box. Double press the power button (Fig.13.A) to turn on handset.
On your handset (1), press and hold [ENG] (Fig.13.I) and [DENG] (Fig.13.J) for 1 second to enter
pairing mode. The indication LED (Fig.13.B) on your handset should continuously flash green. Press
the small sync button as shown in Fig.15 on your FRONT axle electronic control unit (2). The LED on
this box should quickly flash red, before producing a small clicking noise. The indication LED (Fig.13.B)
on your handset should go solid green, and the LED on the electronics control unit (2) change to a
slow red flash to indicate it is paired.
The handset will be in Single Axle mode by default. To select AWD mode, press and hold [RL] (Fig.
13.G) and [FN] (Fig.13.K) for 5 seconds to firstly select Twin axle mode. The handset will bleep once
to indicate the mode has been set to Twin axle. Once again, press and hold [RL] (Fig.13.G) and [FN]
(Fig.13.K) for 5 seconds to select AWD mode. The handset will bleep in a short sequence to indicate
AWD mode has been set. LED's on both electronics control units (2) should now be slowly flashing to
indicate they are synced to one another, and the handset (1).
To test the configuration, ensure the movers are all disengaged with no obstructions, hold [F] (Fig.
13.C). All four rollers should rotate. If no rollers rotate, or only one axle rotates, repeat the AWD setup
process, starting will a full reset of your handset (1) as explained in the note below.
Pairing Mode:
5 sec
Twin Axle Mode:
56
UK
5 sec