Operation - Handset Pairing / Mode Selection; Full Handset Reset; Operation - Mover Engagement/Disengagement - Carbest Cara-Move Manuel D'utilisation

Operation - Handset Pairing / Mode Selection

Note: For the handset (1) to be paired correctly for AWD, it must have not previously established a
connection with either electronic control unit (4). If this is the case, follow the instructions under the
Full Handset Reset section of this manual. Turn off your isolation key to cut the power to the
electronics control boxes (2). Repeat the AWD pairing process as above.
Pairing Mode:

Full Handset Reset

There may be scenarios in which you need to cut pairing memory or reset the default settings of your
handset. If this is the case, complete a full reset of your handset (1) by holding the power button (Fig.
13.A) and [FN] (Fig.13.K) until the handset turns off (around 10 seconds). When your handset is next
turned on, the LED will illuminate solid red. Pair your handset as applicable by following the relevant
section of this manual, ensuring to select both the mover model and also axle mode.
Full Handset Reset

Operation - Mover Engagement/Disengagement

Always ensure your caravan handbrake is on before engaging or disengaging the mover
system to prevent unwanted movement of the caravan. Only release the handbrake when
the movers are securely engaged to the tyres and you are ready to move the caravan.
Automatic Engagement - During transit/installation the engagement motor end block on
Auto-Engage movers may rotate causing tightening. Before first use, place the manual
engagement tool in the rear of the engagement end block (removing plastic cap) and turn
the tool clockwise to ensure it is moving freely, there should be little resistance required to
turn the tool.
Warning! When engaging/disengaging, ensure there is nothing obstructing or preventing the
movement of the motors. Should the motors stop unexpectedly, check the immediate area
for any potential obstructions.
5 sec
10 sec
57
AWD Mode:
UK
5 sec