Installation - Electrical/Electronic Components (Awd Configuration); Operation - Safety Guidelines - Carbest Cara-Move Manuel D'utilisation

Installation - Electrical/Electronic Components (AWD Configuration)

To install an All Wheel Drive configuration on your caravan, two separate electronics systems
effectively need assembling. These two systems will be configured using the handset prior to initial
use, however during installation there are only a few elements which need to be altered.
Start by wiring up your second mover system by following the same procedures stated in the previous
section 'Installation - Electrical/Electronic Components'. Fig.19 displays the wiring schematic for this
rear axle set up. Fig.20 can also be used for a general overview of how the twin axle wiring should be
set up. Follow these diagrams closely to ensure that the movers are powered as intended and do not
work against one another in operation.
Regarding the battery wires, the same isolation key can be used for both systems. To do this, connect
the second electronics box using a length of wire from the isolation key to the box itself. There should
be only a single positive battery wire connected to the battery itself, with two cables then splitting to
the respective boxes via in-line fuses from the isolation switch onward. Use Fig.20 for reference.
To finalise the electrical set up, attach the Data Cable (4) between the relevant ports (Fig.15.DAT) in
the electronic control units (2). Ensure this is firmly in place.
Follow the 'Operation - Handset Pairing' section of this manual closely for instructions on how to set
up your remote control to correctly operate the AWD system.

Operation - Safety Guidelines

Caution! Please read these safety guidelines closely BEFORE to attempting to operate your
caravan mover system.
DO always check movers for any damage, before use.
DO remain aware, at all times, that ground clearance is reduced by around 50mm where the Movers
have been fitted.
DO keep a maximum 5 meter distance between handset and electronics box when in use, to maintain
signal strength.
DO be aware that the mover increases your caravan or trailer weight. So this reduces the payload of
the caravan.
DO always make sure that the rollers are fully disengaged from the tyres when the mover is not in use.
This is better for the tyres and for the mover.
DO always make sure that the rollers are fully disengaged before towing/moving the caravan by
vehicle or manpower. If not damage can be caused to your tyres, mover and the towing vehicle.
DO always make sure that after you have finished using the Mover, the Battery Power Isolation Switch
is switched off, with the key removed and stored in a safe place, out of reach of children or
unauthorised people.
DO always make sure that the remote control handset is stored in a safe place, out of reach of
children or unauthorised people.
53