Settings When A Wall Mounted Room Temperature Controller Is Present; Standard Display; Standard Menu; Configuration Menu - Stiebel Eltron SHF 2000 Utilisation Et Installation

OpEraTiON

Settings when a wall mounted room temperature controller is present

P2: Time format
Parameter P2 allows you to specify whether the time is displayed
in the 12 hour or 24 hour format.
P3: Temperature display units
Parameter P3 is used to specify whether the room temperature is
displayed in degrees Centigrade [°C] or Fahrenheit [°F].
P4: Reset time programs
Activating parameter P4 resets all time programs to the factory
setting.
P5: Reset relative heating time
Activating parameter P5 resets the counter for relative heating
time (I2).
5.3.4 Contractor access
Display Description
CodE Contractor access
Note
Some menu items are protected by a code and can only
be accessed and adjusted by a qualified contractor.
6. Settings when a wall mounted
room temperature controller is
present
Note
If heat transfer (discharge) is controlled via a wall mount-
ed room temperature controller, only a very limited num-
ber of adjustment options are available to you on the
appliance.
6.1

Standard display

The standard display is continuously displayed. If no user action
is performed for longer than 20 seconds while in the menu, the
device automatically switches to the standard display.
The standard display shows the current setting of the charge level
reducer as well as the "Editable parameter" symbol. For days
when the heat demand is lower, you can adjust the charge volume
manually in 10 % increments using the "+" and "–" buttons.
www.stiebel-eltron.com
6.2

Standard menu

Note
You can call up the standard menu only if your appliance
is fitted with a booster heater (accessory).
To access the standard menu, briefly press "Menu".
Display Description
Switch booster heater (accessory) on or off
Even if the wall mounted room temperature controller has a
booster heater switch, the booster heater must be switched
on in the standard menu.
If you wish to change the setting of the menu item, press the "OK"
button.
As soon as the "Editable parameter" symbol appears, you can
change the setting of the menu item with "+" and "–". Press "OK"
to save the setting.
To exit the standard menu, press "Menu". The standard display
appears.
6.3

Configuration menu

Display Description
I2 Actual value
P5 Parameters
CodE Contractor access
To access the configuration menu, press and hold "Menu". After
approx. 3 seconds, actual value I2 is displayed.
Use "+" and "–" to switch between the individual actual value and
the parameter.
To exit the configuration menu, press "Menu". The standard dis-
play appears.
6.3.1 Actual value
Display Description
I2 Relative heating time
(The counter can be reset via parameter P5.)
Note
The counter for relative heating time (I2) counts the
charge time in complete hours run. The counter increas-
es when the appliance has been charged for a full hour,
even if this is split between shorter periods.
6.3.2 Parameters
Display Description
P5 Reset relative heating time
Activating the parameter resets the counter for the
relative heating time (I2).
If you wish to change the setting of the parameter, press the "OK"
button.
As soon as the "Editable parameter" symbol appears, you can
adjust the setting of the parameter with the "+" and "–" buttons.
Press "OK" to save the setting.
Unit
[h]
Options
on | off
SHF | 9