Limiting The Temperature Controller; Shutting Down; Cns 24H Operation; Operating Modes - Stiebel Eltron CNS 50-2 E Mode D'emploi Et Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION

CNS 24H OPERATION

5.3

Limiting the temperature controller

Using the two pins fitted to the back of the control casing, you
can fix the temperature controller at a certain setting or limit the
temperature setting range.
Break out the pins.
»
To prevent adjustment of the selected temperature, push a pin
»
into the hole opposite (see diagram).
1 Pin
2 Temperature selector
To limit the temperature setting range, set the minimum and
»
maximum values at the temperature selector, and push a pin for
each into the slightly offset hole opposite (see diagram).
1 Pin
2 Temperature selector
5.4

Shutting down

Move the switch on the right of the appliance to OFF.
»
WWW.STIEBEL-ELTRON-USA.COM
2
1
1
2
1
1
6.
CNS 24H Operation
The CNS 24H is a convection space heater with a 24-hour timer,
thermostat and an on/off switch.
To switch the appliance off, move the ON/OFF switch
to
6.1

Operating modes

3 3

1 Timer switch

2 ON/OFF switch
3 Arrow marking the time
Heating with the time switch
To set the appliance into the timer mode, move the ON/OFF
»
switch to the
symbol. The appliance turns on in accordance
to the timer settings (see 6.2, "Timer switch", pg. 5).
Appliance off
Move the ON/OFF switch to
»
mode, frost protection is disabled.
Constant operation
Move the ON/OFF switch to to keep the appliance in continuous
»
operation. The appliance will operate until the set temperature
is reached. Frost protection is enabled in this mode.
6.2
Timer switch
In the timer and constant operation modes, the appliance heats
to the set temperature on the temperature selector.
When in timer mode, the appliance will only activate during the
desired time, in addition to the set temperature.
Set the time by turning the timer switch clockwise until the black
»
arrow points to the current time.
Push the tabs on the edge of the time switch outwards for the
»
time that the appliance should heat. Every tab corresponds to
an ON or OFF period of 20 minutes.
Heating ON: Push the tabs outwards.
Heating OFF: Push the tabs inwards.
1
2
2
to turn the appliance off. In this
CNS E / CNS 24H|
5

Publicité

Table des Matières
loading

Table des Matières