Electrical Connection; Operation With External Room Temperature Controller; Appliance Handover - Stiebel Eltron CON 10 S Manuel D'utilisation Et Installation

INSTALLATION

electrical connection

12. Electrical connection
WARNING Electrocution
- Carry out all electrical connection and installation
work in accordance with relevant regulations.
- Do not install the appliance with a fixed power
cable.
WARNING Electrocution
In the case of a permanent connection, the appliance
must be able to be separated from the power supply by
an isolator that disconnects all poles with at least 3 mm
contact separation.
Note
Observe the type plate. The specified voltage must match
the mains voltage.
The appliance is delivered fully wired. The following electrical
connections are permissible:
Connection to a freely accessible standard socket with
matching plug
Permanent connection to an appliance junction box with
earth conductor
- If connecting the appliance via a socket, ensure that this is
easily accessible once the appliance has been installed.
- If connecting the appliance permanently, trim the power
cable so that it leads directly to the appliance connection
socket. Ensure that, after trimming the power cable, the
appliance can still be removed from the wall without a
problem.
13. Operation with external room
temperature controller
In rooms larger than 20 m 2 , you can operate the appliance with
an external room temperature controller.
f Fit the room temperature controller to the wall, as far from f
the appliance as possible, at least 1.5 m above the ground.
f Turn the appliance temperature selector fully clockwise. f

14. Appliance handover

f Explain the functions of the appliance to the user. f
f Draw special attention to the safety instructions. f
f Hand over the operating and installation instructions to the f
user.
16 | CON 10-30 S | CON 10-30 ZS
CON 15-30 S
CON 15-30 ZS
X
X
www.stiebel-eltron.com