Maintenance; Weekly Maintenance - Amanngirrbach ceramill mikro Mode D'emploi

8.2

Maintenance

8.2.1

Weekly maintenance

NOTE:
Danger of damaging the machine!
▷ Do not use compressed air, ultrasonic or a
steam jet for the cleaning!
Prior to maintenance:
Before maintaining the spindle, the spindle sealing
air must be activated:
▷ Briefly press service button [B].
The current tool is placed down and the spindle
returns to the service position. The spindle is
released; the motor is blocked.
▷ Open the door of the Ceramill Mikro.
▷ Press service button [B] on the Ceramill Mikro.
The sealing air is activated. The service button
lights up.
After the maintenance
When the maintenance is completed:
▷ Shut the door of the Ceramill Mikro.
▷ Briefly push operation button [A].
The tool is picked up again. The spindle travels
back to the starting position or to the position,
where the program was interrupted.
Spindle
The provided spindle service set and a milling tool
of your choice are required for maintenance of
the spindle.
In order to clean the spindle:
▷ Remove any dust from the cap and the spindle
using a dry, soft cloth. Do not use cleaning
agents!
C L E A N I N G A N D M A I N T E N A N C E
To remove the collet:
▷ Apply the spindle wrench to the collet.
Fig. 11
▷ Insert a milling tool into the open collet.
▷ Using the spindle wrench, unscrew the collet out
of the spindle.
Fig. 12
▷ Clean the collet holder.
The collet holder must be free of shavings/chips
and debris.
Fig. 13
E N
41