Installation Of The Ceramill Match; And Ceramill Mikro Software - Amanngirrbach ceramill mikro Mode D'emploi

5.3

Installation of the Ceramill Match 2

and Ceramill Mikro Software

▷ Insert the Ceramill Match 2 data carrier into the
drive of the PC.
The data carrier contains a PDF file with the
installation guide.
▷ Open the PDF document and follow the instruc-
tions in the guide.
Connecting the interfaces
1
2
3
4
Fig. 4 Interfaces on the rear side of the
Ceramill Mikro
1 Slot for SD memory card
2 Ethernet interface
3 USB data port
4 Control interface for extraction
5 Main switch
6 Fuse/power supply connection compartment
▷ Make sure that the main switch [5] of the
Ceramill Mikro is in the 0 position.
▷ Check if the SD memory card is properly seated
in the slot [1] on the rear side of the Ceramill
Mikro.
▷ Connect the mains cable to power supply con-
nection [6] of the Ceramill Mikro as well as to a
mains socket outlet.
▷ Connect the control cable to the control inter-
face for extraction [4] on the rear side of the
Ceramill Mikro and to the interface on the rear
side of the extraction system (e.g. Ceramill Air-
stream).
Connecting to the PC
▷ Connect a USB cable to the USB interface ([3] in
fig. 4) of the Ceramill Mikro and to a free USB
port of the PC.
The maximum permitted length of the USB
cable is 5 m.
▷ Insert the Ceramill Dongle in a free USB port on
5
6
the rear side of the PC.
100 /11 5/2 30V AC
I
0
230 V
T3. 15A
110 /11 5V
T6. 30A
Fig. 5
I N S T A L L A T I O N
Ceramill Dongle
E N
33