Amanngirrbach ceramill mikro Mode D'emploi page 35

▷ Insert the selected blank into the holder in the
Ceramill Mikro. The high/thick side of the blank
must face the inward.
Fig. 7 Inserting a blank
▷ Fasten the blank using four screws and washers.
NOTE:
Do not damage the blank!
▷ Do not overtighten the screws! Avoid mechan-
ical stress!
▷ Tighten the screws with the Allen key provided.
Fig. 8 Tightening a blank
▷ Shut the door of the Ceramill Mikro.
▷ Switch the Ceramill Mikro on via the main
switch.
▷ Switch the PC on.
I N S T A L L A T I O N
▷ Start the Ceramill Motion Software.
When the software is started, a machine initiali-
sation takes place.
If the Ceramill Mikro is not detected:
▷ Restart the PC.
After re-positioning the Ceramill Mikro, it
is necessary to check the system axes.
▷ For this, observe the instructions for
milling the test bodies.
E N
35