Dentsply Sirona Lucitone Digital Print Mode D'emploi page 8

C. Procedure for Fabrication: FUSE (BOND)
For post-curing a Try-In, skip to section E.
Note: Section C should be done under proper ventilation. Use of personal protective
equipment is recommended.
1. Plug in the electric hot plate and set the temperature to 90˚C.
Note: If the electric hot plate is not digital, set to 100˚C.
Allow the electric hot plate to preheat for at least ten (10) minutes.
Note: The temperature setting may need to be adjusted slightly from the recommended
setting due to several factors.
2. Place IPN 3D Digital Denture Teeth into respective pockets to check for a dry it.
3. Shake the bottle of Lucitone Digital Fuse Step 1 - 3D
Tooth Conditioning Agent to ensure contents are
thoroughly mixed. Pour enough Fuse Step 1 into the
round metal container to ill to top of the foam insert.
(Figure 9) Refer to Precautions.
CAUTION: Using an inadequate amount of Fuse Step 1
will compromise tooth bond strength.
CAUTION: Keep the metal container and the foam
insert free of any solid buildup. This can compromise
the tooth bond strength.
4. Use tweezers to place up to fourteen (14) IPN 3D
Digital Denture Teeth into the holes so that the teeth
are positioned with the ridge lap down and in contact
with the liquid. If the liquid is not level with the top of
the foam insert, add additional Fuse Step 1 to metal
container. Immediately replace the lid on the container.
(Figure 10)
5. Place the tooth-illed container inside the metal ring of
the electric hot plate until the 40°C rectangle on the
temperature strip turns green (normally in four (4) to six
(6) minutes). Refer to Precautions. (Figure 11)
CAUTION: Tooth bond strength will be compromised if
40˚C is not reached or if higher warming temperatures
are used to accelerate the process.
6. Carefully remove the metal container from the electric
hot plate. Remove the lid from the metal container and
use tweezers to retrieve the teeth. Allow teeth to air dry
for minimum of two (2) minutes. Do not wipe teeth.
6
Figure 9
Figure 10
Figure 11