Encoder Parameters Page; Camera Settings Page - Videotec MAXIMUS MVXHD Manuel D'instructions

5.4.10 Encoder Parameters page

In the Encoder Settings menu, it is possible to
configure up to 4 video flows of the device. The first
flow must be compressed with the algorithm H.264/
AVC while the others can alternatively use MJPEG
coding. For all the flows, you can set the video size,
the frame rate, use of the rate controller and the
I-Frame Interval (GOP size).
The OSD section allows configuration of the On
Screen Display (OSD) with the possibility of setting
a title for the video before compression. Lastly,
it is possible to configure the IPv4 address for
configuration of multicast video streaming. Editing
this setting will cause the device to restart.
Fig. 25
16

5.4.11 Camera Settings page

The camera integrated in the device can be
configured under the Camera Parameters menu:
• Extensive mode: This mode allows more precise
control of the settings.
• Digital Zoom: It allows enabling or disabling the
digital zoom. (in addition to the optical).
• Focus: It allows setting the focus in automatic or
manual mode. The types of autofocus available in
automatic mode are:
• Normal: Standard autofocus mode
(recommended option for PTZ devices).
• Interval: Mode in which autofocus is activated
in certain time intervals settable by the
user (autofocus interval=every how many
seconds the autofocus is enabled, duration of
movements=for how long the autofocus is on).
• Zoom Trigger (recommended option for fixed
devices): Mode in which autofocus is activated
for 5s each time the zoom position is modified.
• In automatic mode, you can set the autofocus
sensitivity:
• High: Autofocus is activated on every
minimum change of scene the camera is
focused on (recommended option for PTZ
devices).
• Low: Autofocus has little sensitivity to
varying the scene the camera is focused on
(recommended option for fixed devices).
MNVCMVXHDCAM_1813_EN