User Configuration Page; Digital I/O Page; Wiper; Washer Page - Videotec MAXIMUS MVXHD Manuel D'instructions

5.4.6 User Configuration page

On the menu item, the users who can access the
device can be administered.
As planned by ONVIF protocol, there can be three
types of users: Administrator, Operator, User.
These types of users can have limited access to the
functions exported by ONVIF protocol, but do not
have web page restrictions. This product only allows
a single Administrator type user with the admin
username.
Fig. 22
The device can be configured only by users
with administration privileges.
The Administrator user name cannot be
changed.

5.4.7 Digital I/O Page

From menu entry Digital I/O it is possible to configure
the digital channels available in the device. What
follows is a brief description of the configurable
parameters for each digital input.
• Alarm ID: Field used to select the desired digital
input.
• Type: It indicates the default state of the digital
input.
To check correct operation of the alarms, a dot will
appear on the web page. The dot will be green
in normal conditions and red when an alarm is
detected.
Fig. 23
MNVCMVXHDCAM_1813_EN

5.4.8 Wiper

Do not use the wiper if the outside
temperature is below 0°C or in case of ice.
The integrated wiper does not interfere with the
viewing range of the installed camera.

5.4.9 Washer page

From the Wash System menu, it is possible to
configure the device wash system functions.
• Enable: Enables the washer functions.
• Wiper-on Delay: Time interval that passes
between the moment the water is supplied and
the moment the wiper is enabled.
• Wash Cycle Duration: Duration of the water
supply by the pump.
• Wiper-off Delay: Duration of the brushing cycle
after water supply has been terminated.
Fig. 24
15