Removing The Oven Door - Franke CA 52M Mode D'emploi Et Installation

Removing the oven door

To facilitate cleaning the oven, the oven door can be removed as follows:
– The hinges (A) are equipped with two moveable locks (B). Lift the lock (B) to release
– Now raise the door upwards and pull it out; to do this, hold the door at its sides next
– To refit the door, first slide the hinges into their grooves.
– Finally, before closing the door, remember to turn the two moving locks (B) previously
The internal glass panel of the oven door can be removed to enable thorough cleaning, as
follows:
– Open the door completely.
– Remove the two terminals at the top corners of the door using the corresponding
– Remove the internal glass panel.
DETAIL C
After cleaning, refit the internal glass panel, taking care that the lower edge fits below the
tabs at the lower section of the door and ensure correct fixture by means of the rubber
elements. Then insert the two upper terminals until the buttons click into place.
WARNING
– Do not wash any removed parts (terminals and glass) in the dishwasher.
– When refitting the internal glass panel ensure that the screen printed face (opaque
Never use the appliance before the internal glass panel has been refitted
completely.
the hinge.
to the hinges.
used to release the hinges.
buttons (see detail C).
side) of the panel is facing downwards.
B
A
21