Technical Data; Installation Instructions; Safety Instructions - Truma MonoControl CS Mode D'emploi

Technical data

(determined in accordance with EN 16129:2013 or Truma test
conditions)
Type of gas
Liquid gas (propane / butane)
Admission pressure
0.3 – 16 bar
Output pressure
30 mbar or 50 mbar, depending on variant
Regulator capacity
1.5 kg/h
Regulator inlet
Male thread M20 x 1.5 (G.13)
Regulator outlet
Olive screw connection, 8 mm or 10 mm (H.9)
Recommended tightening torque
3 – 5 Nm for union nut M20 x 1.5 (G.13)
Horizontal triggering value
3.5 g ± 0.5 g
Operating temperature
‑30 °C to +50 °C
Declaration of conformity
The Truma MonoControl CS gas pressure regulation system
complies with the pressure equipment directive 2014/68/EU,
with the application of EN 16129:2013 and conforms to the
UN ECE R122 Appendix VIII "Safety regulations for combustion
equipment and heating systems for liquid gas (LPG)". Complies
with the directive UN ECE R10 "Radio interference suppression
in vehicles" and has the type approval number: E1 04 4352
Product ID number
CE‑0085BQ0102
DG approval number: 3894
16
Subject to technical changes.

Installation instructions

The unit may only be installed and re-
paired by an expert. Read the installation
instructions carefully before working, and
then comply with them!
Disregarding installation instruc-
tions or erroneous installation
can put people in danger and cause
damage to property.

Safety instructions

– Residual gas: No smoking, no naked flames!
– If the MonoControl CS gas pressure regulation system is
installed in the flow direction downstream of another press‑
ure regulation device, the supply pressure range must
correspond to the regulated pressure range of the upstream
pressure regulation device, taking into account the pressure
loss of the pipeline in between.
– In the case of caravans and motor homes with 30 mbar
consumers, the maximum pressure loss ΔP of the down‑
stream installation to the consumer must not exceed
5 mbar (ΔP5).
– In order to ensure that the equipment operates correctly, the
gas pressure regulation system must be securely screwed
to a stable wall / ceiling (with 2 screws).