Maintenance And Lubrication; End Of Season Maintenance - Grillo G110 Manuel D'entretien

Translation of the Original Instructions

MAINTENANCE AND LUBRICATION

CAUTION!
- Disconnect the plug before performing any cleaning, maintenance or repair operation.
Always wear suitable clothing and working gloves.
- When the machine or part of it is lifted to carry out maintenance operations, always
remember to use suitable fixing tools such as holders and safety locks.
- When carrying out maintenance operations and/or when the machine is tilted without
safety locks or supports, never leave it unguarded in places where inexperienced people
and children could have easy access to it.
- Protect the environment: carefully dispose of used oils, petrol and any other pollutant
product!
- Effective maintenance and correct lubrication help to keep the machine fully efficient.
RUNNING-IN: change the engine oil after the first 20 working hours.
ENGINE – Follow the instructions outlined in the engine's manual. In general users are advised to
check the oil level every 8 working hours and to change it every 100 hours (fig. 5, A). Always use
15W40. Check the air filter oil level (fig. 7A) every 8 working hours or more often in very dusty
conditions. Top up with the same oil as for the engine (see engine handbook). On versions with dry
filter (fig. 7), replace the cartridge if clogged (do not clean with compressed air jets).
GEARBOX – Check the oil level every 50 working hours by removing the cap and checking with
the machine horizontal the oil reaches between the two notches. If necessary add MP 80 W/90
(API GL5 US-MIL-L-2105D) oil. Change the oil once a year (fig. 6).
ROTARY TILLER – Check the oil level every 100 hours by removing the plug; the oil must almost
fill the rotary tiller box. If necessary add the same oil as for the gearbox (fig. 4, n. 3).
TIPS FOR EFFICIENT USE
1) Always release the red clutch lever (fig. 3A, n. 1) before shifting form the forward gear to the
reverse gear and vice-versa.
2) Always release the red clutch lever (fig. 3A, n. 1) before engaging the PTO.
3) Never leave the machine exposed to bad weather condition.
4) Keep cables and lever always clean from dust and residues and the handlebar system always
well lubricated.
5) Never force the reverse gear: If the gear does not engage immediately check that the PTO lever
is not engaged (fig. 3A, n. 13).
6) Never strain the engine: if smoke comes out of the exhaust, slow down.
7) Hard grounds can be tilled too, make sure the engine is warm and the machine has been well
run-in first.
8) Frequently check the tyre pressure.
9) When fitting the implements (e.g. rotary tiller) take care not to damage the centring device of the
walking tractor gearbox (fig. 4C).

END OF SEASON MAINTENANCE

Carefully wash the walking tractor, replace the oil in engine and the gearbox oil, clean the air filter.
Sharpen the hoes and grease them. Replace them if worn. IMPORTANT: The hoes of Grillo
walking tractors are made of a special steel subjected to heat treatments. Never weld the
hoes if broken or cracked, because they could break and be flung away becoming therefore
highly dangerous for people and objects around.
13