Grillo G110 Manuel D'entretien page 20

Translation of the Original Instructions
ADJUSTABLE WHEELS SPACER
These innovative screw spacers are advisable above all for ploughing. If you have to change the
track gauge, please unlock the two keys kept by the springs, start the machine, put the first gear,
block the differential lock and release the clutch when the engine is at minimum; in this way the
track gauge is automatically changed. Attention not to unscrew them completely. Position the keys
and respective springs again. Now you can change the track gauge, lifting the machine and
operating manually (fig. 25).
BACK-CUTTER FURROWER
This tool is mounted at the rear of the tiller and works in tandem with it. The furrower is designed to
produce irrigation and seed drills (fig. 26).
ORIENTABLE FRONT BLADE – 125 cm
This highly resistant device is ideal for removing snow and levelling mounds of soil or gravel. May
be tilted to the right and left (fig. 27). The front blade is attached to the walking tractor with an
implement frame and the handlebar must be turned 180towards the engine and then follow the
instructions outlined for the mower bar.
ORIENTABLE BRUSH – 100 cm
This brush (fig. 28) can be attached to the machine following the mower bar's instructions. It is very
useful to clean roads and squares. It can also be used to clean up 10-12 cm high fresh snow and it
can be steered left or right to make drifts. The brush is attached to the walking tractor with an
implement frame and the handlebar must be turned 180° towards the engine. Then follow the
instructions outlined for the mower bar. To operate the orientable brush the safety device must be
positioned as shown (fig. 2A). Important: when reconnecting the rotary tiller, the safety device
must be set in the original position. We do not accept any responsibility for failure to follow
this rule (fig. 2).
WARNINGS FOR TRANSPORT
Walking tractors cannot be used on public roads. If the machine is to be transported on a lorry or a
trailer, lower the handlebar, engage the 1 st gear, fasten the walking tractor to the lorry/trailer using
ropes or belts. If a lifting machine is used to lift the walking tractor from the ground into the
lorry/trailer make sure its lifting capacity its suitable for the walking tractor.
18