Filling the Internal Water Reservoir
CAUTION!
❐ Always pull out the plug before you top up/empty the water reservoir. Always pull the
plug and never the cable.
❐ Never pour any additives into the water reservoir. This could destroy the device and
safe working is no longer guaranteed.
❐ Never exceed the maximum fi ll level (note MAX marking on the water reservoir!).
The useful service life of the device will be extended if you use pure distilled water.
For steam-ironing just a few garments, it is suffi cient if you fi ll the internal water reservoir
of the device with water.
1. Make sure that the device is not connected to the mains power. Move the steam
quantity control (2) to position
Filling/Using the External Water Reservoir in the Storage Station
If you want to iron a large number of garments, we recommend that you use the external
water reservoir. It holds 1.4 litres and does not need to be topped up as often as the
smaller internal water reservoir of the iron. This allows you to work faster.
5. Place the storage station on a fl at, stable surface and position the iron on top of it.
.
2. Place the iron upright on its base (12) on a fl at surface and
fl ip open the water reservoir catch (20). Please note that
the catch cannot be completely detached from the device.
3. Fill the reservoir up to the MAX marking (17) with the aid of
the measuring cup which is supplied. The reservoir holds
approx. 250 ml.
4. Close the water reservoir by fl ipping the cover shut again.
Make sure that the water reservoir is completely sealed
shut.
1. Make sure that the device is not in the storage station.
2. Flip open the water reservoir catch (27). Please note that
the catch cannot be completely detached from the device.
3. Fill the reservoir up to the MAX marking (25). You can ei-
ther use the measuring cup or hold the feed opening di-
rectly beneath a tap.
4. Close the water reservoir by fl ipping the cover shut again.
Make sure that the water reservoir is completely sealed
shut.
28