Dry-Ironing - Cleanmaxx AS8128 Mode D'emploi

Label Material / temperature setting
WOLLE (wool)
BAUMWOLLE (cotton)
JEANS (denim)
LEINEN (linen)
Not suitable for ironing
We recommend that you sort the garments on the basis of the temperature they
need to be ironed at and that you start with the items which require the lowest
temperature. Otherwise, wait a few minutes when you adjust the device from a
high temperature to a lower level before you continue ironing.
2. Place the device to heat up in the storage station or upright on a stable, fl at and heat-
resistant surface.
6
The symbol (c) on the display indicates that no water or too little water is present in
the water reservoir (15).

Dry-Ironing

The water reservoir does not need to be fi lled for dry-ironing.
1. Move the steam quantity control (2) to position
"Temperature Setting" section.
2. Wait until the device has heated up and the
display. The device is then ready for use and you can start ironing.
3. Plug the mains plug of the device into a properly installed
5
mains socket that is easily accessible. All symbols appear
on the display for a short time.
a
4. Press the
b
light up and the device begins to heat up to the lowest
temperature setting SAMT (velvet).
5. You can now press the
perature setting. A bar
chosen setting.
6. During the temperature adjustment (temperature increase
c
or reduction), the
When the set temperature has been reached, a beep is
heard and the symbol is lit up permanently.
Steam setting
on / off button (5). The operating lamps (13)
button (6) to select another tem-
(a) on the display indicates the
symbol (b) fl ashes on the display.
and follow the instructions in the
symbol is lit up permanently on the
27