Steam-Ironing - Cleanmaxx AS8128 Mode D'emploi

6. Connect the mains plug of the iron to an easily accessible plug socket.
• If there is no water or too little water in the external water reservoir, the device stops
pumping after a few seconds. Fill the water reservoir in the manner described above.

Steam-Ironing

CAUTION!
❐ Never aim the steam directly at people, animals or plants. This can cause severe
scalding.
For an optimum ironing result, we recommend that you dry-iron the fabric after
steam-ironing it in order to remove the moisture from it.
1. Fill the external or internal water reservoir with water (see previous sections).
2. Move the steam quantity control (2) to position
3. Place the device to heat up into the storage station or upright on a stable, fl at, heat-
resistant and moisture-resistant surface.
4. Plug the mains plug of the device into a properly installed mains socket that is easily
accessible.
5. Press the on / off button (5).
6. Use the button (6), depending on the care label of the fabric which is to be ironed,
to choose the medium (
Setting" section). Steam-ironing is possible in this range.
7. Wait until the device has heated up and the
display.
7. Press the
starts automatically when you do this. The water from the
external water reservoir is pumped into the internal res-
ervoir of the iron. As this happens, the pump display (14)
lights up. Wait until the pumping process has been com-
pleted and the pump display has gone out before you start
ironing.
) to maximum (
8. Use the steam quantity control to set the desired quantity
of steam (for
start ironing. During steam-ironing, hold down the Eco
button (16).
9. If the water reservoir is empty or contains too little water,
no more steam is generated and the
on the display. Move the steam quantity control to
out the mains plug and top the water reservoir up again.
29
on / off button (5). The pumping process
.
) temperature (see the "Temperature
symbol is lit up permanently on the
and for or ). You can now
symbol appears
, pull