Dry-Ironing; Filling The Water Reservoir - Cleanmaxx LB-116 Mode D'emploi

❐ Only iron on a stable, fl at, heat-resistant and moisture-resistant surface. We recom-
mend that you use a standard ironing board.
❐ Do not iron on surfaces made from glass or plastic.
❐ Always work with suffi cient lighting.
❐ Always test the device fi rst on a small, inconspicuous spot on the clothing.
❐ Never iron for too long on one spot to prevent damage to the clothing.
❐ Do not iron over zips, studs, clips etc. to prevent any scratching of the ceramic coat-
ing on the bottom of the iron.
❐ Open the water reservoir cover only to fi ll the water reservoir. Otherwise keep the
cover closed while operating the iron.
❐ Place the device on an even, stable and heat-resistant surface during and shortly
after use. Always place the device upright on its base to prevent damage to the sur-
face which could be caused by the hot bottom section of the iron.
NOTE: The fi rst time you use the device, you might notice a small amount of smoke. This
is harmless and will cease as you use the device.

Dry-Ironing

1. Check the label in the garment for the required ironing temperature and set this using
the temperature control (5). The temperature setting you want must be positioned
next to the marking (4).
2. Make sure that the
is not activated.
3. Place the device to heat up upright on a stable, fl at and heat-resistant surface.
4. Plug the mains plug of the device into a properly installed mains socket that is easily
accessible.
5. As the device heats up, the temperature control lamp (2) lights up. Wait until the
device has heated up and the temperature control lamp goes out. The device is now
ready for use and you can start ironing.
6. After use, pull the plug out of the plug socket, place the device upright on its base
and allow it to cool down completely.

Filling the Water Reservoir

CAUTION!
❐ Always pull out the plug before you top up/empty the water reservoir. Always pull the
plug and never the cable.
❐ Never pour hot water, any cleaning agent or other additives into the device. This
could destroy the device and safe working is no longer guaranteed.
❐ Never exceed the maximum fi ll level (note max marking on the water reservoir!). The
useful service life of the device will be extended if you use pure distilled water.
1. Make sure that the device is not connected to the mains power and the
button (11) is not pushed in and thus steam emission is not activated. Turn the steam
quantity control (10) counter-clockwise as far as it will go to position Min.
On/Off button (11) is not pushed in and thus steam emission
21
On/Off