Installation; General Considerations; Installation Configurations - Palazzetti ECOFIRE TWIGGY Notice D'installation Et D'entretien

Masquer les pouces Voir aussi pour ECOFIRE TWIGGY:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

6

INSTALLATION

6.1

General considerations

In the following paragraphs some indications
are provided to be respected in order to obtain
the maximum performance from the purchased
product.
The following indications are how-
ever subject to compliance with any
possible national, regional and mu-
nicipal laws and regulations in force
in the country where the appliance is
installed.

6.2 Installation configurations

It is possible to install the stove in different ways
according to requirements:
• Coaxial pipe
• Single wall pipe and room air intake
• Single wall pipe and air intake connected to the
outside
48
6.2.1 Coaxial pipe
It is possible to use a coaxial pipe for the expul-
sion of fumes and for simultaneous recovery of
the combustion air.
To achieve this:
• Connect a coaxial pipe (A) as the stove is al-
ready configured in the factory for this type of
installation (Fig. 17)
It is understood that it is the responsibility of the
technician to size the flue according to the instal-
lation situation and to the product. It is however
advisable not to exceed 7 meters equivalent with
an 8/13 cm coaxial pipe.
A
Fig. 17
004771070 - 17/11/2020

Publicité

Table des Matières
loading

Table des Matières