Removal From The Transport Pallet; Transportation; Checking The Floor Where The Appliance Will Be Placed - Palazzetti ECOFIRE TWIGGY Notice D'installation Et D'entretien

4.1 Removal from the transport pallet

To remove the appliance from the transport
pallet, remove the screws as shown in Fig. 3.
The disposal of materials can also be entrusted
to third parties, provided that companies author-
ised to recover and eliminate the materials in
question are always used.
Always and in any case comply with the regula-
tions in force in the country in which the appli-
ance is being used for the disposal of materials
and, if necessary, for the declaration of disposal.

4.2 Transportation

Make sure that the lifting carriage has a
payload higher than the weight of the
appliance to be lifted. The full responsi-
bility of the lifting of loads lies with the
person handling the lifting equipment.
Pay particular attention to protecting
wooden flooring or parquet floors in
order to avoid possibly ruining them
due to the weight of the appliance
when moving it.
During lifting, avoid jerking or abrupt movements.
Pay attention to overbalancing.
4.3 Checking the floor where the
appliance will be placed
Check the load capacity of the floor slab.
42
In the case of a floor that is not suitable to sup-
port the weight of the appliance, install suitable
steel plates (A - Fig. 4) or concrete base (A - Fig.
5) equipped with 10x10x6 electro-welded mesh
10x10x6 (B - Fig. 5) to distribute the weight.
For the dimensions of the plates and
the concrete base, use a qualified
technician.
A
Fig. 3
A
B
Fig. 1
10 mm
Fig. 4
Fig. 5
004771070 - 17/11/2020