Rear Smoke Outlet - Palazzetti ECOFIRE TWIGGY Notice D'installation Et D'entretien

5.7 Rear smoke outlet

The stove is designed to convert the smoke
outlet pipe from top to rear (Fig.
Fig. 15).
Remove the back plate (A), rear inspection cap
(B), the smoke cap (C) and the upper smoke
collar (D) by loosening the screws of each indi-
vidual component.
A
• Fit the smoke cap (C) on the upper side of the
stove in place of the previous position of the up-
per smoke collar (D).
• Close the upper hole by joining the aesthetic
cap (F) to the support ring (E) using the 6 nuts
supplied. Align the assembly with the top by
adjusting the nuts.
• Fit the upper flue collar (D) on the rear side of
the stove in place of the previous position of the
flue cap(C).
• Remove the pre-cut from the rear inspection
cap (B) and mount the component in its pre-
vious seat.
• IT IS possible to connect the flue pipe (G) to the
collar (D) (Fig. 16).
004771070 - 17/11/2020
ITALIANO ENGLISH
14 -
D
B C
Fig. 14
DEUTSCH FRANÇAIS
B D
G
ESPAÑOL
F
E
C
Fig. 15
Fig. 16
47