Yamaha Motor 20C Manuel D'entretien page 190

LOWR
DISASSEMBLY
19. Forward gear bearing outer race and shim.
Using special service tool.
20. Taper roller bearing.
Using special service tool.
21. Taper roller bearing
Using special service tool.
22. Drive-shaft needle-bearing.
Using special service tool.
Note the following points:
1. For ease of reassembly and adjustment,
keep shim packs in their groups as
removed.
2. If a bearing carrier or bearing race is diffi-
cult to remove, warm the part with a gas-
torch.
3. To remove an oil-seal and bearing, follow-
ing the instructions in the illustrations.
4. Replace any bearing which shows signs of
damage on inspection.
6-5
E