Improper Use; Personnel Qualifications; Safety Instructions In This Document - Aventics ED05 Notice D'instruction

AVENTICS | ED05 | R414002533–BAL–001–AG
2.2

Improper use

It is considered improper use when the ED05 pressure regulator
is used for any application not named in these instructions,
is used under operating conditions that deviate from those
described in these instructions.
2.3

Personnel qualifications

Assembly and commissioning require basic electrical and
pneumatic knowledge, as well as knowledge of the appropriate
technical terms. Assembly and commissioning may therefore
only be carried out by qualified electrical or pneumatic
personnel or an instructed person under the direction and
supervision of qualified personnel. Qualified personnel are
those who can recognize possible hazards and institute the
appropriate safety measures due to their professional training,
knowledge, and experience, as well as their understanding of
the relevant conditions pertaining to the work to be done.
Qualified personnel must observe the rules relevant to the
subject area.
2.4

Safety instructions in this document

In this document, there are safety instructions preceding the
steps whenever there is a danger of personal injury or damage
to the equipment. The measures described to avoid these
hazards must be observed.
Safety instructions are set out as follows:
SIGNAL WORD
Type of risk
Consequences
Precautions
Safety sign (warning triangle): draws attention to the risk
Signal word: identifies the degree of hazard
51
For your safety