Installation; Mounting - Burkert 8025 UNIVERSAL Notice D'utilisation

3 INSTALLATION

3.1 MOUNTING

Installation Guidelines
The device must be protected from the rain, constant heat radiation and
other environmental influences such as magnetic fields or direct exposure
to sunlight.
3.1.1 Panel-mounted version (fig. 3.1)
Respect the installation specifications described in the instruction manual of the remote
sensor.
Follow the instructions below to install the transmitter:
1. Use the supplied drilling jig to cut away the necessary opening in the panel. Make sure to
scrupulously respect the dimensions indicated.
2. Place the gasket on the 4 screws of the cover.
Note: Use the 4 M4x25 screws supplied if the panel door is too thick.
3. Place the cover+gasket set on the cut-away with the electronic board facing the inside of
the panel.
4. Insert the 4 washers onto the 4 screws and fit the device to the panel using the 4 nuts.
5. Connect according to instructions described in chapter 3.2.
6. Use the supplied 4 cable clips to fit the cables to the protective plate.
Nut
Gasket
FIG. 3.1
Mounting 8025 Universal, panel-mounted version
Washer
E-8-
8025 UNIVERSAL
Screw
Cable clip