How To Use The Cable Clips; Using Switch "Sensor Supply; Using Switches "Flow Sensor" And "Sensor Input Load - Burkert 8025 UNIVERSAL Notice D'utilisation

Masquer les pouces Voir aussi pour 8025 UNIVERSAL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3 INSTALLATION

3.2.2 How to use the cable clips

FIG. 3.3
Using the cable clips

3.2.3 Using switch "SENSOR SUPPLY"

Before connecting the remote sensor to the 8025 Universal, make sure that switch "SEN-
SOR SUPPLY" on the electronic board of the 8025 Universal is correctly positioned.
FLOW SENSOR
SENSOR SUPPLY
1
+5V
2
+12V
3
L+

3.2.4 Using switches "FLOW SENSOR" and "SENSOR INPUT LOAD"

Before connecting the remote sensor to the 8025 Universal, make sure that switch "FLOW
SENSOR" ("COIL" as default setting) to select the type of sensor connected and switch
"SENSOR INPUT LOAD" ("3" as default setting) to select the type of sensor output, on the
electronic board of the 8025 Universal, are correctly positioned.
Before wiring the device, insert the sup-
plied cable clips into the cuts of the elec-
tronic board and, if fitted, into the cut of the
115/230 VAC power supply board.
SENSOR SUPPLY switch
Position 1
Position 2
Position 3 (default setting)
E-12-
8025 UNIVERSAL
Voltage supplied to the remote sensor
+5 VDC
+12 VDC
+27 VDC, if the 8025 Universal is powered by a
115/230 VAC supply
or the 8025 Universal power supply minus 2 VDC,
if the 8025 Universal is powered by a 13-30 VDC
supply

Publicité

Table des Matières
loading

Table des Matières