Parameter Settings And Functions; Chlorine Output; Viewing The Measured Ph And Redox Values (Ees Pro Only); Setting The Ph And Redox Set Point (Ees Pro Only) - BWT EES Notice De Montage

FROM NOW ON THE SYSTEM WILL RUN AUTOMATICALLY, MONITORING THE WATER
CHEMISTRY AND PRODUCING CHLORINE UPON DEMAND!
8.

PARAMETER SETTINGS AND FUNCTIONS

8.1

Chlorine output

On the EES models only, the chlorine output can be adjusted manually by the user by pressing the two
arrow keys ▲ and ▼.
This setting will be saved to memory for when the device is started in the future, even if it is disconnected
from its power supply in the mean time.
EES Pro models automatically adjust the Chlorine output depending on the Chlorine demand detected,
the user may not intervene manually. Nota bene: while there is no Chlorine demand, and so no Chlorine
production, the output scale is not displayed on the screen.
8.2

Viewing the measured pH and redox values (EES Pro only)

!
IMPORTANT To ensure the accuracy of the pH sensor, calibrate the sensor before setting the set
point. See the calibration procedure in paragraph 10.2 et 10.3.
On EES Pro, use the ▲ and ▼ arrow keys to view the pH and Redox potential measured by the
sensors:
• Press one of the two arrows once, the measured pH value is displayed.
• Second press, a few seconds after the first, the Redox potential is displayed.
• The display returns to AUTO after a few seconds.
8.3

Setting the pH and redox set point (EES Pro only)

8.3.1 pH
• The pH measures the degree of acidity or alkalinity of the water and has a strong influence on the efficacy
of Chlorine, and on bather comfort.
• The pH set point is set at 7.5 in the factory.
• The pH set point may be modified within the range 7.0 – 8.1.
To do this:
• Press twice on the
60/80
2021/02 - Indice de révision : E - Code : 29650
button: the current pH set point will be displayed.
TRAITEMENT DE L'EAU