Replacing The Double Brake - Verlinde STAGEMAKER SL5 504 M2 A D8+ Manuel Du Propriétaire

9. Install the new brake on the shaft.
1.
2.
3.
There may be two extra screws on the
brake. The screws are used during
REMARQU
transportation to keep the brake
E components together. Remove these
two screws when you have installed the
new double brake.
REMARQU The top brake is the main brake, and the
bottom brake is the secondary brake.
E
10. Plug in the brake cables (1) and (2).
11. Install the end cover on the brake side.
For more information, see chapter Removing and installing the hoist covers.
12. Tighten the screws of the end cover to the correct tightening torque.
For more information, see chapter Tightening torques for the chain hoist.
13. Turn on the power to the hoist.
14. Check that the brake works normally.
1.
2.
3.
7.4.6

Replacing the double brake

1. If a load is attached to the hook, remove it.
2. Disconnect the chain hoist from the main power supply network.
3. Remove the end cover on the motor side.
Le présent document et les informations qu'il contient sont la propriété exclusive de Verlinde S.A.S. Lesdites
informations sont considérées comme privées, confidentielles et appartenant à leur propriétaire et ne peuvent ni être
reproduites, divulguées auprès de tiers, ni modifiées ou utilisées de quelque manière que ce soit sans l'autorisation
écrite de Verlinde S.A.S. Copyright 2020 © Verlinde S.A.S. Tous droits réservés.
Secure the fixation with the three
screws. Pre-tighten the screws by
hand.
Tighten the screws with a tool.
If the brake has two more screws,
remove the screws.
First test the brake without any load.
Then test the brake with a dynamic test load of 110% (EUR) or 125% (US) of the rated
capacity. Size of the dynamic test load depends on the country regulations.
In the European countries, test the brake also with a static test load of 125% of the
rated capacity.
2
1
1. Main brake
7 MAINTENANCE
2. Secondary brake
4/2020