Connecting The Hoist To Power Supply - Verlinde STAGEMAKER SL5 504 M2 A D8+ Manuel Du Propriétaire

Figure 13. Cable gland positions of the chain hoist configuration B
1. Power supply
4.8.2

Connecting the hoist to power supply

If the chain hoist is ordered without plugs, these instructions show you how to connect the chain
hoist to the power supply.
Before connecting the chain hoist to the main power supply network, check that
• rated voltages correspond to the main voltage. Check the voltages and frequencies that are
marked on the data plate of each product or component. For example, motors that are driven
by a frequency converter may have different values on their data plate than the values of the
chain hoist.
• power supply to the chain hoist is protected with fuses of correct size.
ELECTRICAL SHOCK HAZARD
The chain hoist is delivered with a short power supply cable that is attached to the
power supply socket. The short power supply cable is only a temporary cable which is
not properly insulated. Connecting the temporary cable to the power supply can cause
an electric shock, which could lead to death, serious injury, or damage to the product.
Never connect the chain hoist to the power supply using the temporary power supply
cable. Remove the temporary power supply cable on the site and replace it with the
main power supply cable. Replace the temporary power supply cable before
connecting the chain hoist to the power supply.
Le présent document et les informations qu'il contient sont la propriété exclusive de Verlinde S.A.S. Lesdites
informations sont considérées comme privées, confidentielles et appartenant à leur propriétaire et ne peuvent ni être
reproduites, divulguées auprès de tiers, ni modifiées ou utilisées de quelque manière que ce soit sans l'autorisation
écrite de Verlinde S.A.S. Copyright 2020 © Verlinde S.A.S. Tous droits réservés.
1
2
AVERTISSEMENT
MANUEL DU PROPRIÉTAIRE
2. Control cable
4/2020