Sygonix 2299890 Notice D'emploi page 37

• To end the deletion process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
Scheduling the timer for the relay output or switching to
toggle mode
The potential-free changeover contact of the code lock can be
activated with a transponder.
The following functions are possible:
• The changeover contact is activated for 2....99 seconds
(default setting 5 seconds); optimal e.g. for a door opener.
• The changeover contact is activated for 100 ms (pulse mode);
optimal e.g. for controlling an alarm system..
• Toggle mode: The changeover contact switches between
the two switch settings for each valid access attempt. For
example, this is optimal for arming/disarming an alarm
system..
Proceed as follows:
• The code lock must be in standby mode and the LED
indicator must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator will then flash red.
Example:
• Press the
key. The LED indicator will switch to constant
key. The LED indicator will light up orange.
37