Sygonix 2299890 Notice D'emploi page 34

• Press the
indicator (2) will switch to constant red to indicate that the
code lock is in standby mode.
Second option: Delete transponders using specific user IDs
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
will turn orange. The code lock is now in delete mode.
• Enter the user ID that you want to delete via the remote
control and complete your entry with the
Example:
• When the transponder has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn orange again. The user ID for
this transponder has now been deleted.
If the user ID cannot be found in the code lock memory,
the code lock will emit 3 short beeps and the LED
indicator (2) will flash red before switching back to
orange.
• You can now delete other user IDs.
34
key to exit programming mode. The LED
key on the remote control. The LED indicator (2)
key.