Sygonix 2299890 Notice D'emploi page 30

• When the desired or maximum number of transponders have
been added, press the # key to finish adding the cards. The
LED indicator (2) will flash red.
• Press the
indicator (2) will switch to constant red to indicate that the
code lock is in standby mode.
Third option: Adding a user transponder by entering the
8/10-digit transponder number:
After entering the 8/10-digit transponder number, the code lock
automatically associates the next available user ID with this
transponder number. However, it is not possible to see which
user ID was assigned. To add the user transponder, proceed as
follows:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
code lock is now in add transponder mode.
• Enter the 8 or 10-digit transponder number. Press the
to confirm your entry. The LED indicator will briefly turn green,
and then orange again.
• The new user transponder will be associated with the
automatically assigned user ID.
30
key to exit programming mode. The LED
key. The LED indicator (2) will turn orange. The
key